Alvarion BreezeACCESS 4900 User Manual Page 171

  • Download
  • Add to my manuals
  • Print
  • Page
    / 242
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 170
Chapter 2 - Managing a Single Device/Cell IP Parameters Page
AlvariCRAFT Device Manager 156 User Manual
2.24.3 DHCP Settings
DHCP Option The DHCP Option displays the current status of the DHCP support,
and allows selecting a new operation mode. The following options are
available:
Disable: To configure the IP parameters manually. If this option is
selected, configure the static IP parameters as described above.
DHCP Only: The unit will search for and acquire its IP parameters,
including the IP address, subnet mask and default gateway, from a
DHCP (Dynamic Host Configuration Protocol) server only. If this
option is selected, you must select the port(s) through which the unit
searches for and communicates with the DHCP server, as described
below. You do not have to configure static IP parameters for the unit.
DHCP messages are handled by the units as management frames.
Automatic: The unit will search for a DHCP server and acquire its IP
parameters from the server. If a DCHP server is not located within
approximately 40 seconds, the currently configured parameters are
used. If this option is selected, you must configure the static IP
parameters as described above. In addition, you must select the
port(s) through which the unit searches for and communicates with
the DHCP server, as described below.
Access to DHCP The Access to DHCP option enables defining the port through which
the unit searches for and communicates with a DHCP server. Select
from the following options:
From Wireless Only
From Ethernet Only
From Both Ethernet And Wireless
Page view 170
1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 241 242

Comments to this Manuals

No comments