Alvarion BreezeACCESS 4900 User Manual Page 77
- Page / 242
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Chapter 2 - Managing a Single Device/Cell Air Interface Spectrum Analysis Page
AlvariCRAFT Device Manager 62 User Manual
Click on the Activate Spectrum Analysis button to activate the spectrum
analysis process. Upon activation, the unit will reset automatically and start-up in
spectrum analysis mode. If there is connectivity to the unit, the Current Status
will change to Active.
Click on the Reset Counters button to clear the previous analysis results (if any)
from the Spectrum Analysis Table.
2.6.2 Spectrum Analysis Table
The read-only Spectrum Analysis Table displays the following results for each of
the scanned frequencies:
In addition, the Spectrum Analysis Table section includes the following
components (applicable only if there is connectivity to the unit during the test):
Channel The frequency in MHz.
Signal Count The number of signals (excluding OFDM frames with the correct
bandwidth) in the channel.
Signal SNR (dB) The average SNR of signals (excluding OFDM frames with the
correct bandwidth) in the channel.
Signal Width (microsec) The average width in microseconds of signals (excluding OFDM
frames with the correct bandwidth) in the channel.
OFDM Count The number of OFDM frames with the correct bandwidth detected in
the channel.
OFDM Avg SNR The average SNR (in dB) of OFDM frames received in the channel.
Avg Noise Floor The average Noise Floor (in dBm) calculated for the channel.
Max Noise Floor The maximum Noise Floor (in dBm) calculated for the channel.
Signal Max SNR The maximum SNR (in dB) of signals (excluding OFDM frames with
the correct bandwidth) in the channel.
OFDM Max SNR The maximum SNR (in dB) of OFDM frames received in the channel.
Refresh Interval The refresh interval for the Spectrum Analysis Table to be used in
Automatic refresh mode (see Start/Stop Automatic Refresh).
The range is 5 to 1000 seconds. The default is 5 seconds.
The Refresh Interval parameter is available only during an active
spectrum analysis test
- User Manual 1
- BreezeACCESS 1
- Legal Rights 2
- Disclaimer 3
- Limitation of Liability 4
- Important Notice 5
- About This Manual 6
- Contents 10
- Using AlvariCRAFT 16
- In This Chapter: 17
- 1.1 Installing AlvariCRAFT 18
- 1.2 Introduction 19
- 1.3 Getting Started 20
- 1.4 Using the Device Manager 26
- 1.4.2 Common Control Buttons 27
- 1.4.5 Grayed-out Fields 28
- 1.4.7 Working with Tables 29
- 1.5 How to Get Help 30
- 1.5.1 The Help Navigator 31
- 1.5.1.1 Table of Contents Tab 32
- 1.5.1.2 Index Tab 32
- 1.5.2 The Help Topic Window 33
- Menu Sub-Menu* Description 34
- Icon Tooltip Description 34
- Managing a Single Device/Cell 36
- 2.2 The Device Page 39
- Parameter Description 41
- 2.2.2 The Device Versions Tab 44
- Control page 45
- General Parameters 48
- ESSID Parameters 49
- Noise Immunity Parameters 49
- Noise Floor Parameters 49
- 2.3.1 General Parameters 50
- 2.3.4 ESSID Parameters 54
- 2.3.6 Noise Floor Parameters 59
- 2.4.1 Frequency Definition 64
- 2.4.5 DFS Detection Algorithm 67
- 2.5.1 Transmit Power Table 71
- The HW revision of the unit 72
- 2.5.3 General Tx Parameter 73
- 2.5.4 ATPC Parameters 74
- Spectrum Analysis Table 76
- 2.6.2 Spectrum Analysis Table 77
- Parameters Page 79
- 2.7.1 Basic Parameters 80
- 2.7.3 Advanced Parameters 81
- 2.7.4 Output Parameters 82
- 2.10.2 Details 90
- 2.11 Gateways Page (AU Only) 91
- AP (BU) 92
- APs (AU)/Wi 92
- (RB Only) 94
- Best AU/Best BU Parameters 95
- 2.15.11 General Controls 104
- Per RB Counters Page (BU) 106
- RB Only) 111
- 2.19 Bridging Page 112
- 2.19.1.1 General Parameters 116
- List Tab (AU Only) 129
- Add button: a new line 131
- Revert button 131
- Apply button 131
- 2.20 Service Parameters Page 132
- Disable 145
- 2.20.2.3 IP Range Option 147
- Parameters Tab (AU Only) 148
- 2.22 Security Parameters Page 154
- 2.23.2 RTS Threshold (bytes) 160
- 2.23.4 AVG SNR Memory Factor 160
- 2.23.7 Burst Mode Parameters 162
- 2.23.9 AIFS (AU and SU Only) 165
- 2.24 IP Parameters Page 170
- 2.24.3 DHCP Settings 171
- General Tab 172
- 2.25.1.3 IP Addresses Table 175
- Traps Tab (AU and BU Only) 176
- 2.26 Unit Control Page 177
- 2.26.1 General 179
- 2.26.2 Software Control 179
- 2.26.3 Configuration Control 181
- 2.28 Software Upgrade Page 188
- 2.30.2.1 Unit Control Screen 194
- 2.30.2.2 IP Parameters Screen 195
- 2.30.2.5 Best AU Screen 198
- 2.30.2.12 Security Screen 205
- 2.31.2.1 Unit Control 207
- 2.31.2.2 IP Parameters 210
- 2.31.2.4 Best AU 212
- 2.31.2.5 Bridging - VLAN 213
- 2.31.2.7 Service - General 215
- 2.31.2.9 Security 218
- 2.32 Performance Page 220
- Parameters Summary 224
- 3.1 AU/SU Device General Page 225
- 3.8 Best AU/BU Page 230
- 3.9 Bridging Page 230
- 3.10 Service Parameters Page 233
- Enable 236
- 3.11 Security Parameters Page 237
- 3.13 IP Parameters Page 240
- 3.15 Unit Control Page 242
Related products and manuals for Routers Alvarion BreezeACCESS 4900
Routers Alvarion BreezeNET DS.11 User's Guide
(117 pages)
(117 pages)
Routers Alvarion BreezeACCESS 4900 User Manual
(119 pages)
(119 pages)
Routers Alvarion BreezeACCESS VL User Manual
(10 pages)
(10 pages)
Routers Alvarion BreezeNET DS.11 User Manual
(66 pages)
(66 pages)
Routers Alvarion BreezeNET DS.11 User's Guide
(192 pages)
(192 pages)
© 2020, manymanuals.com. All rights reserved. | 0.787 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals