Chapter 3 - Commissioning Configuring Basic Parameters
BreezeACCESS 4900 51 System Manual
Frequency (AU) The lowest frequency in the
selected Sub-Band
User Defined Frequency
Subsets (SU)
A (All) The list of all frequencies in the two
available Sub-Band.
Transmit Power 20 dBM @ 10 MHz Bandwidth
(Sub-Band 1)
17 dBm @ 5 MHz Bandwidth
(Sub-Band 2)
In SU, Transmit Power cannot be higher
than the Maximum Tx Power
parameter.
Maximum Tx Power (SU) 20 dBM @ 10 MHz Bandwidth
(Sub-Band 1)
17 dBm @ 5 MHz Bandwidth
(Sub-Band 2)
Tx Power (AU) On
Antenna Gain (units with
external antenna)
According to the antenna supplied
with the unit and the Sub-Band.
If set to "Not Set Yet", must be
configured according to actual value,
taking into account cable's attenuation.
ATPC Option Enable
Best AU Support (SU) Disable
Preferred AU MAC Address
(SU)
00-00-00-00-00-00 (none) Applicable only when Best AU Support
is enabled.
Cell Distance Mode (AU) Automatic
Maximum Cell Distance (AU) 0 (No Compensation)
Fairness Factor (AU) 100 (%)
Per SU Distance Learning (AU) Disable
Maximum Modulation Level
(SU)
8 Refer to
Section 3.3.
Wi2 IP Address (SU) 0.0.0.0 (none)
VLAN ID-Management 65535
Authentication Algorithm Open System
Data Encryption Option Disable
Security Mode WEP
Default Multicast Key (AU) Key 1
Promiscuous Authentication
(AU)
Disable
Default Key (SU) Key 1
Table 3-1: Basic Parameters
Parameter Default Value Comment
Comments to this Manuals